Page 1 of 1

Voltage cut off termination

Posted: Sat Oct 28, 2017 4:51 pm
by Opi
Mark, in your long cycle life test of the eneloop cells you said you cut off the charge voltage at a fixed 1.44v. Was that a custom setting you wrote for your charger or is there any suggestions on how to approximate a fixed termination voltage cut off with only the 1.0 version of the firmware?

Re: Voltage cut off termination

Posted: Sun Oct 29, 2017 11:42 am
by Mark
It has been a while, so to be honest, I don't remember how I did it - sorry!