Search found 5 matches

by Opi
Sat Oct 28, 2017 5:42 pm
Forum: General Discussion
Topic: Did the onboard mode and button interface change for the shipping version?
Replies: 1
Views: 278

Did the onboard mode and button interface change for the shipping version?

Looking at the QuickStart and UserGuide I'm wondering if the actual shipping v3 charger had any changes to the Mode and button press functionality? The v3 board doesn't have a charging rate switch so that functionality has been removed. What happens when the Mode switch is on "charge mode"...
by Opi
Sat Oct 28, 2017 5:28 pm
Forum: General Discussion
Topic: Charger's hardware / firmware version
Replies: 3
Views: 2940

Re: Charger's hardware / firmware version

Here's what it says for my charger which was purchased and delivered from the Kickstarter project: "Logging Started HW Version 3.01 FW Version 1.000 Compiled Jun 28 2015 Serial # 281" Just note that the kickstarter shipping charger doesn't look like any of the pictures show in the UserGuid...
by Opi
Sat Oct 28, 2017 4:54 pm
Forum: Battery Test Results & Reviews
Topic: Eneloops: 5000 cycles and still going...
Replies: 14
Views: 14221

Re: Eneloops: 5000 cycles and still going...

Mark, on the graphs you created showing the long term cycle life of eneloop cells, I assume you pulled the ending capacity data from each completed cycle to make the chart, is there an easy way to do that without manually searching and then copy and pasting that data pulled from each completed cycle...
by Opi
Sat Oct 28, 2017 4:51 pm
Forum: Battery Testing Discussion
Topic: Voltage cut off termination
Replies: 1
Views: 204

Voltage cut off termination

Mark, in your long cycle life test of the eneloop cells you said you cut off the charge voltage at a fixed 1.44v. Was that a custom setting you wrote for your charger or is there any suggestions on how to approximate a fixed termination voltage cut off with only the 1.0 version of the firmware?
by Opi
Fri Oct 20, 2017 4:33 pm
Forum: General Discussion
Topic: Video
Replies: 12
Views: 11004

Re: Video

Actually, it could be a micro USB cable that you need - Paul did mention to me previously that he was looking at changing to micro USB. My board don't have it. I've sent a message to Paul via Kickstarter. It should be automatically detected as a COM port. You could try emailing Paul directly, or if...

Go to advanced search